SMEG Dishwasher Repair Guides

For inconsistent cleaning on a Smeg DI613ATP, first compare the dirty areas with the loading pattern, then inspect the spray arms and filters with the dishwasher disconnected from power. Smeg's opened DI613-family user manual says to use the correct detergent amount, regenerating salt, a program suited to the load and soil level, clean and correctly seated filters, clear spray-arm nozzles, and no object blocking arm rotation.

Grit on items after a Smeg DIC6 cycle is not enough to identify one failed part. First describe the material: soft tablet fragments point toward detergent dissolution, hard white or chalky marks toward water hardness or softener settings, and brown or food-like particles toward leftover food or an obstructed accessible filter path.

A bad smell from a Smeg dishwasher is usually narrowed by retained food or standing water in the filter and sump area, a drain path issue, detergent residue, or a door left closed while damp. Clean accessible parts and stop if the smell is electrical or sewage-like.

A Smeg dishwasher that stops before completing a cycle should be checked for water supply, drain flow, door closure, filter condition, and any displayed signal. A repeated stop after those checks needs model-specific service.

A Smeg dishwasher door that will not close is commonly blocked by a rack, dish, seal, plinth, or alignment issue. Remove the obstruction without forcing the latch and escalate if the door or hinge is damaged.

A Smeg dishwasher error display must be recorded exactly with the full model and point in the cycle. Codes and reset steps are model-specific; the code alone does not identify a replaceable part.

Water leaking from a Smeg dishwasher should be contained immediately and traced to the door seal, filter area, hose, or inlet protection. Close the water supply and keep the dishwasher off if water reaches the floor or electrical area.

Smeg dishwasher noise can come from the pump, spray arms, circulation motor, dishes, or installation. A single click or water sound can be normal; scraping, grinding, or a sudden loud change calls for service.

Standing water in a Smeg dishwasher is first checked at the filter, sump, drain hose, and sink connection using owner instructions. Do not reach into a running pump or dismantle the appliance.

When a Smeg dishwasher is not working, first check whether the on/off indicator or display is blank, whether a cycle is selected, and whether the door is fully closed. Then verify the outlet and breaker, open water tap, program selection, and any delay-start or fault indication.

Treat visible sparks, an electrical flash, crackling, or a flash followed by a trip as an electrical safety event. Stop the Smeg dishwasher and do not start another cycle or reach into the tub, under the appliance, or behind a panel.

Treat sparks together with a burning smell from a Smeg dishwasher as an electrical and fire-safety event. Stop the cycle, switch the appliance off and unplug it only if the plug and surrounding area are safe to reach; otherwise isolate the circuit from a safe location.

The opened SMEG thread confirms the assigned symptom: the dishwasher kept draining after a wash interruption, and the original poster found rice starch in the filter trap. A later report in the same thread describes a SMEG DWA6214X2 with the same continuously running pump, a split lower spray arm and water in the tray underneath; that is a reported case, not proof for every SMEG model.

The exact report identifies a Smeg ST65120 and says the 65° and 70° buttons in the END section flash together. A reply in that same report suggests the lights can indicate that a cycle has ended, while the person reporting the problem says the dishwasher seems stuck.