Kenmore Washer Dryer Repair Guides

Treat a Kenmore washer-dryer alert as model-specific until the exact code and model number are recorded. Stop immediately for smoke, a burning or electrical smell, a hot or damaged cord, water near electrical parts, an active leak or overflow, or a drum that will not stop safely.

If a Kenmore washer-dryer is leaking, stop the cycle, keep people away from the wet floor, and turn off the water supply. Unplug the appliance only when the plug and surrounding area are dry and it is safe to do so.

A Kenmore washer-dryer that leaves water in the tub may have a kinked or displaced drain hose, a user-serviceable filter blocked with debris, an overfilled or badly loaded cycle, or a pump, sensor, lock, or control fault. First stop the cycle and protect against flooding and electrical contact.

Start by deciding whether the clothes enter drying already waterlogged, whether the dryer tumbles without heat, or whether heat is present but moisture cannot leave. Use a correctly sized load and the intended heated or sensor cycle; Air Dry and other no-heat settings will not dry normally.

First determine whether the Kenmore washer-dryer is failing to heat wash water, or whether the dryer portion tumbles but produces no warm air. A dryer can appear to work on an Air Dry or no-heat setting, and exact cycles vary by model.

First identify whether your Kenmore appliance is a stacked laundry center, a washer-dryer combo, or separate washer and dryer units; the start conditions differ by model. Record the full model number and use Kenmore's official manual lookup, which requires the model to find the correct owner documentation.

Start by separating a blank control panel from a machine that has power but will not start, and from a cycle that starts and then stops. Check the household supply, the door or lid closure, the selected cycle, and visible water inlet and drain hoses without opening the cabinet.