Repair problem
Not Functioning Troubleshooting Guides
Published FixGraph guidance for diagnosing and responding to not functioning.
Matching published guides
Choose a guide that matches the service, equipment, and conditions you are seeing.
-
Breville BOV900 Not Functioning After Shipping Damage: PCB Repair Safety
If a Breville BOV900 toaster oven stopped working after shipping damage, do not open it to repair or replace a suspected PCB. First unplug it and inspect the outside, plug, and cord for shipping damage without removing covers.
-
JennAir JDB9800CWX2 Not Functioning: How to Check a Discontinued Part
Treat a non-functioning JennAir JDB9800CWX2 as an identification and safety problem before searching for a discontinued part. Record the complete model and serial numbers, the exact symptom, and any display or light pattern.
-
Panasonic NN-ST775S built into a cabinet: safe checks before removing the trim
Do not pry the trim or remove the microwave's outer case just because a Panasonic NN-ST775S has stopped working. First identify whether the display is dead, the controls will not start, the door will not close, the turntable or fan behaves abnormally, or the oven runs without heating.
-
Samsung DW80M2020US/AA/00 Dishwasher Not Working with the Normal Light Blinking
On a Samsung DW80M2020US/AA/00, a blinking Normal light with the dishwasher not working is not proof that flushing the hot-water heater caused a control-board or valve failure. Samsung's US blinking-light guide maps the Normal-only pattern to moisture detected by the leak sensor, and says the dishwasher may turn itself on and keep trying to drain.
-
Samsung Microwave SE or 5E After Steaming Orange Peels: Safe Checks
On Samsung microwaves, an actually displayed SE or -SE- is associated with a touch-key condition; Samsung's regional guidance describes a key held too long or a key-short error and says dust or water on the button can be involved. After boiling orange peels, steam or condensation is a credible trigger, but a seven-segment display that looks like 5E must be photographed rather than assumed to be SE because codes vary by model and market.
-
Siemens E 44.10 dryer: a mains filter burst after years unused
Treat a Siemens E 44.10 dryer whose mains filter burst on first energization as an electrical safety event, not as an ordinary no-power or filter-replacement problem. Do not reconnect it, bypass the filter, substitute a guessed part, reset a breaker repeatedly, or open the cabinet.
-
Whirlpool JT469/SL microwave shows Door after cleaning
For the Whirlpool JT469/SL, a Door message can be the documented start-protection state: the manual says the door must be opened and closed before cooking can start. Because this began after cleaning, first leave the microwave disconnected until the door area and controls are fully dry, then wipe only accessible surfaces with a soft damp cloth if residue remains; do not spray directly into the oven.
-
Whirlpool WMH31017AS1 Arced at the Light Socket: Stop Using It
Do not run the Whirlpool WMH31017AS1 again after an arc at the WPW10498011 light-socket area, even if the magnetron still heats and the display and buttons work. Disconnect power only from a safe, dry position, without touching a hot, scorched, wet, or damaged cord or outlet.