Repair problem
Not Running Troubleshooting Guides
Published FixGraph guidance for diagnosing and responding to not running.
Matching published guides
Choose a guide that matches the service, equipment, and conditions you are seeing.
-
Amana ADB1300AFS1 Not Running After Circulation Pump Replacement
For the Amana ADB1300AFS1 dishwasher, “circulation pump error” is not a phrase listed in the opened Amana dishwasher error-code table, so it should be treated as an unconfirmed label rather than proof that the replacement pump is bad. Record the exact display or the two-part clean-light pattern, verify the model through Amana’s Owner Center, and first check only the external power state, door latch or Control Lock, accessible water supply, and visible leaks.
-
Frigidaire FAD704DWD Dehumidifier Compressor Stops in High Humidity: What to Check
A Frigidaire FAD704DWD compressor may run for a long time in a very humid room, and it should stop when the measured relative humidity reaches the selected setpoint. The fan can continue for up to about 3 minutes after the compressor stops.
-
GE GFD65GSSVWW Dryer E20 Error After a Down Comforter
On the GE GFD65GSSVWW gas dryer, E20 after a wet down comforter is a stop-and-check event, not proof that a thermistor or control board has failed. An exact-model community report describes a saturated comforter, a wet lint-trap area, water in the exhaust duct, an E20 display, and a dryer that would not run; a reply interpreted the code as extreme heat sensed, but GE's public model pages do not publish a universal E20 repair meaning.
-
KitchenAid KRSC703HPS ice dispenser does not run when the paddle is pressed
KitchenAid identifies KRSC703HPS as a 22.6-cu-ft counter-depth side-by-side refrigerator with exterior ice and water. If pressing the paddle produces no auger action, first separate an ice-production problem from a dispenser problem: verify that ice is actually in the bin, the doors are closed, Control/Dispenser Lock is off, the selected ice mode is correct, the bin is seated, and ice has not clumped or blocked the chute.
-
LG DLE2101W Dryer Shuts Off After About 5 Minutes
A five-minute shutdown does not identify a thermal fuse, motor, or control board. First confirm the full LG DLE2101W model and whether the dryer comes back on after stopping.
-
LG DLE6100W Dryer Runs for a Few Minutes and Then Stops
On the LG DLE6100W, a Sensor Dry cycle can end early when the load is too small to keep contacting the humidity sensors, or when residue prevents the sensors from reading the load. That is different from the dryer losing power, stopping with an error, or shutting down with a normal-sized load.
-
Maytag MED5630HW2 Dryer Runs for One Second After a Loud Noise
Do not keep restarting the Maytag MED5630HW2 after it made a strong noise and then began running for only about one second. The exact model is identified by Maytag's parts document as an electric dryer, and Maytag's own guidance treats loud grinding, rumbling, scraping, or a dryer that stops spinning as a reason to stop and arrange professional assessment.
-
Sharp SMC0912BS Microwave Flashes and Clicks While Idle: Separate the Clock from a Safety Fault
Do not run the Sharp SMC0912BS again just to identify a clicking sound. This exact model is a Sharp countertop microwave with a blue LED display, clock/timer, touch controls, and a child-safety lock.